A: The ZRC1-IR codes are as follows. UP_KEY = 0x07ED112B STOP_KEY = 0x07F519C3 DOWN_KEY = 0x07DD089B How to use the wireless 5-12 volt trigger feature Requires a 3.5mm to 3.5mm mono cable (not included). The Radio Frequency (RF) remote control serves as a dual purpose, independently as a handheld remote control, or as a Wireless…
A: Yes, please follow the steps below to change the Radio Frequency code. How to change the RF code Remove the batteries Change the RF code switch Insert the batteries Synchronize it with the wall box controller
A: Yes, the ZRC1-RF Radio Frequency remote can be programmed with its own unique code to control multiple screens by changing the RF code as described below. How to change the RF code Remove the batteries Change the RF code switch Insert the batteries Synchronize it with the wall box controller
A: Follow the directions below to synchronize/pair a new ZRC1-RF remote. Note: The wall box controller is needed for this operation. Press & hold the “Programming Key”, then press the “Up Key” on the Wall box controller (wall-box LED indicator light flashes). Then press the “Up Key” on the RF remote The Wall box LED…
A: The exact radio frequency range of the ZRC1-RF is 433.93 MHz.
A: The effective beam range 20 ft (6 M) within a 30° angle.
A: Please reference the circuit board layout below. Circuit Board | ZRC1-CKT-X Connection port for 110V AC Power Connection port for electric screen tubular motor RJ50 port for connecting wall box controller Emergency stopper Infrared signal receiver Radio Frequency signal receiver Switch for selecting screen type Position 1 (Right) = Down/UP Retractable Wall/Ceiling Screen Position…
The RF remote is not rechargeable and requires one button cell CR2032 battery.
Elite provides binary codes for the IR remote, see below. Series Up Stop Down CineTension 2 Series 1111 0000 0001 1111 0000 0010 1111 0000 0100 Evanesce / Evanesce Tab-Tension B 1111 0000 0001 1111 0000 0010 1111 0000 0100 Home2 Series 1111 0000 0001 1111 0000 0010 1111 0000 0100 Spectrum Series 1111 0000…
AF5D-30 is capable of scaling 2D material to 3D. Please note, the input source frame rate should not be 24Hz or 30Hz. We recommend users apply 60Hz input source.
Stacking Multiple Projectors to amplify lumens (brightness) will not change the Projection Image Contrast Ratio. (Ex. if you stack 2pcs of 2500 Lumens, 10,000 Contrast Ratio Projectors, you should get 5000 Lumens and same 10,000 Contrast Ratio).
Airflex5D is an image processor that allows you to stack multiple projectors to create one single image. By using multiple projectors, Airflex5D effectively increases the brightness of the image. This not only increases the performance of any projection system, it is also very cost effective (See how Airflex5D saves cost HERE). Compared to typical high…