Manual B Series

No, but Elite provides D RINGS attached to each end cap for a suspended ceiling installation.

For a complete comparison of the Manual B series and our other Manual series, please click here to view a comparison table.

No, the Manual B series screen can be locked in 5 cm intervals.

The main difference between the Manual B is the a thinner matte white surface, no top/bottom black masking borders and a 5cm stop and lock position. In contrast, the Manual Series has left/right/top/bottom black masking borders, a thicker matte white surface, and a 2cm stop and lock position.

A: The screen should always be retracted into the housing when not in use to prevent the material from detaching off the roller and to keep the screen surface clean. Please note that leaving the screen down for extended periods after use may cause the screen material to detach from the roller and is not covered under warranty.

Although each installation is unique, the screw size we recommend and provide is M550mm. We have found that this screw size will provide enough length to support a Spectrum, VMAX2, or Manual screen installation in most instances. For drywall installations, the Φ1040mm wall anchors (also included) should be installed along with the M5*50mm screws. **Please not that there are many other factors to consider when installing a screen such as the location of the wall studs and thickness of the wall. Each circumstance is different. If you are unsure about the stability of the wall or ceiling in regards to the screen installation, please contact a professional installer. Elite Screens will not be held responsible or be otherwise liable for faulty installations.

It depends on how high you want to hang the screen. If you are planning on a high ceiling or in-ceiling installation, use a product with an extra black masking border like E24 (24″ drop) or E30 (30″ drop) model. Aside from that, our general product lines will accommodate your typical home or commercial presentation room ceiling heights.  All of our manual and electric screens are suitable for wall or ceiling installations.

Give a light jerk in a downward motion to disengage the locking cam. This will allow the spring to draw the screen material up. Guide the screen as it retracts until it has reached its preferred height setting, then pull it down slightly and ease the material until it has locked into place.

No, but Elite provides D RINGS attached to each end cap for a suspended ceiling installation.

Elite’s Manual series of projection screens are completely self contained and can be easily removed from their present fixtures. All that is required is to lift the screen casing upward until its mounting attachment disengages from the wall screws (wall installation) or the D-rings disengage from the ceiling hooks (ceiling installation). The screen can then be carried to another mounting location without any need for disassembly.

First, check to see if your screen can be pulled further down an additional 1-2 inches. If so, pull the screen down towards your stomach at a 45 degree angle and release to retract. If this procedure does not work, the screen will need to be re-tensioned. Your manual screen can easily be re-tensioned, please see the instructions HERE. Please contact our Technical Support dept. for technical support at [email protected]

No, the manual pull-down screen screen does not have the option to be put on a tripod stand.

No, the manual screen cannot be converted into an electric screen.

No, Elite manual and electric projection screens are not designed for use as a window curtain and should never be exposed to direct sunlight.  Prolonged exposure to solar radiation will destroy synthetic materials and such damage is not covered by our standard warranty.

If you are not able to pull the screen down two inches when attempting to retract it, give the screen a quick yank downwards with a little bit of force. Please be sure to not stand directly under the housing of the unit when yanking down on the screen.

A: The screen should always be retracted into the housing when not in use to prevent the material from detaching off the roller and to keep the screen surface clean. Please note that leaving the screen down for extended periods after use may cause the screen material to detach from the roller and is not covered under warranty.